BTM/2P/600/2200/B/G Double Pillar 500 Litre Wheelie Bin Tipper This 500 Litre Double Pillar Wheelie Bin Tipper is designed to lift and tip a 500 Litre Wheelie Bin at a discharge height of 2200mm. The 500 Litre Wheelie Bin Tipper is constructed from Grade 304 stainless steel, is fully welded throughout and is designed to be bolted to the floor. The lifting is accomplished via chains driven by a motor gearbox mounted at the top of the one column with a crossover shaft to the other column. Safety Guard to BS EN 14120:2015 Safety of Machinery Guards The safety guard is constructed from 40 x 40 x 3mm stainless steel box section and 3mm wire, 40mm aperture stainless steel weld mesh to meet the guidelines of BS EN 14120:2015 Safety of Machinery Guards. It encloses the 500 litre Wheelie Bin Tipper to a height of 2200mm on two sides, approximately 2000mm on the tipping side with a hinged guard door on the fourth side. The guard door is electrically and mechanically interlocked preventing the 500 Litre Wheelie Bin Tipper from operating when the door is open. Additionally, the guard door can only be opened when the lift carriage is at the full down position to prevent access whilst a load is raised. 500 Litre Wheelie Bin Tipper Electrical Control This 500 Litre Wheelie Bin Tipper is fitted with an IP65 Stainless Steel Control Panel which is mounted on the Safety Guard at a convenient position to give good maintenance access under the Provision and Use of Work Equipment Regulation 1998 (PUWER).The control panel incorporates the following controls; Up, Down, Guard Release, Emergency Stop and a Reset Facility. Upper and Lower end of travel limit switches are positioned to prevent inadvertent adjustment or damage but are easily adjustable by trained personnel for fine adjustment on site. The guarded 500 Litre Wheelie Bin Tipper operation is latched so that pressing the ‘Up’ push button once will raise the lift to the full tip position. Once the product has been discharged, pressing the ‘Down’ push button once will return the machine to the full down position. The control panel has a volt free pair of contacts which can be used to connect a ‘Call to Run’ signal if required.
|